Table of Contents
Advertisement
Figure 76. Installing the Riser 2c
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
3. Install any device drivers required for the card as described in the documentation for the card.
Removing expansion card from the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the air
shroud.
4.
Remove the expansion card
Steps
1. Pull and lift up the expansion card retention latch lock to open.
2. Hold the expansion card by its edges and pull the card until the card edge connector disengages from the expansion card
connector on the riser.
After working inside your
Safety
instructions.
Before working inside your
risers.
system.
system.
Installing and removing system components
85
Advertisement
Table of Contents
