Tcp/Ip Settings; Configure Static Addressing Using The Device - Xerox ColorQube 9201 System Administrator Manual

Network Installation

TCP/IP Settings

This section explains how to set up the device to operate in a Windows TCP/IP environment. The
following information is provided:
• IPv4 on page 67
• IPv6 on page 68
• Supporting LPR Printing
• Configure Raw TCP/IP Printing
• Configure SLP on page 72
• SNMP on page 73
• SSDP on page 78
• Microsoft Networking
• AppleTalk on page 80
• Create an IPP Printer (Internet Printing Protocol)
The device supports IP versions 4 and 6. IPv6 can be used instead of or in addition to IPv4.
IPv4 Settings can be configured directly at the device user interface, or remotely, via a web browser
using Internet Services. IPv6 can only be configured using Internet Services. To configure TCP/IP
Settings using Internet Services, see

Configure Static Addressing using the Device

Information Checklist
Before starting the procedure, please ensure the following items are available or have been performed:
• Existing operational network utilizing the TCP/IP protocol.
• Ensure that the device is connected to the network.
• Static IP Address for the device.
• Subnet Mask Address for the device.
• Gateway Address for the device.
• Host Name for the device.
Enter a Static IP Address
1. At the device and press the <Log In/Out> button to enter the Tools pathway.
2. Enter the Administrator's User Name [admin], touch [Next], enter Password [1111], touch
[Enter].
3. Press the <Machine Status> button, and then the [Tools] tab.
4. Touch [Network Settings].
5. Touch [TCP/IP Settings].
64 Xerox ColorQube™ 9201/9202/9203
System Administrator Guide
on page 70
on page 71
on page 78
Configure TCP/IP Settings using Internet Services
on page 80
on page 67.