Xerox ColorQube 9201 System Administrator Manual page 99

3. If prompted, enter the Administrator User ID and Password. The default is [admin] and [1111].
4. Click on the [Login] button.
5. Click on the [Connectivity] link.
6. Click on the [Protocols] link.
7. Select [AppleTalk] in the directory tree.
8. In the General area:
a. For Protocol, check the [Enabled] checkbox to enable the AppleTalk.
b. Type a name for the device in [Printer Name]. The default name is based on the device's
Ethernet MAC address.
c. Enter details in the [Zone Name] filed. An AppleTalk zone is a logical group of nodes or
networks. Zones are assigned according to a logical scheme such as organizational
departments or physical locations.
Note: The default local zone is identified as "*". This should only be changed if you have defined
zones on your network.
d. Physical Connection displays physical network connection. This will display "Ethernet".
e. Printer Type displays the current assigned printer type. This will display "LaserWriter".
9. Click on the [Apply] button to accept the changes or [Undo] to return the settings to their
previous values.
10. Click on the [OK] button when you see the message "Properties have been successfully
modified".
Note: The settings are not applied until you reboot the device.
11. Click on the [Status] tab, select [Description & Alerts] in the directory tree.
12. Click the [Reboot Machine] button and click [OK] to reboot the machine. The network controller
takes approximately 5 minutes to reboot and network connectivity will be unavailable during this
time.
Install the Print Driver
Refer to the Print and Fax Drivers Guide for Macintosh on the Internet Services Print and Fax Drivers CD
for detailed instructions.
1. View the Configuration Report and note the Name given to the device under AppleTalk Settings.
At the Macintosh Workstation
2. Load the Internet Services Print and Fax Drivers CD-ROM into your CD drive.
3. Open the CD and locate the [Drivers] folder.
4. Locate and open the [Mac] folder.
Instructions for Version 10.x (OS X)
1. Double-click to open the folder containing the drivers for version 10.x.
2. Double-click to open the [machine model.dmg].
Double-click to open the [machine model.pkg] file.
3.
4. When the Welcome screen displays, click [Continue].
5. Click [Continue], then [Agree] to accept the License Agreement.
Xerox ColorQube™ 9201/9202/9203
System Administrator Guide
Network Installation
91