Quick Setup - Xerox ColorQube 9201 System Administrator Manual

Device Connection and Quick Setup
Settings, to enable use of the device's web user interface for network and options configuration. If
necessary, reset TCP/IP addressing (including DHCP and DNS settings) and enable HTTP as follows:
1. At the device and press the <Log In/Out> button to enter the Tools pathway.
2. Enter the Administrator's User Name [admin], touch [Next], enter the Password [1111], then
touch [Enter].
Tip: This password can be changed by following the steps provided in the Administrator Tools
topic in the General Setup section of this guide.
3. Press the <Machine Status> button, and then the [Tools] tab.
4. Wait for the screen to refresh, touch [Network Settings], touch [Advanced], if a warning message
appears, touch [Continue].
5. Touch the [HTTP Settings] button, touch [Enable], touch [Save], then touch [Close] to return to
the Network Setting screen.
6. Touch [TCP/IP Settings].
7. Configure TCP/IP settings, including DHCP (Dynamic Addressing) and DNS, touch [Save], touch
the [Close] button to return to the Network Setting screen.
Note: This device supports IPv6 addressing, with an automatically-built Link Local Address for
broadcasting to routers that can supply the network-layer configuration parameters. See
Configure Network connectivity Protocols with Internet Services

Quick Setup

When your device is configured with an IP address and HTTP is enabled, you can configure network
information from your web browser via Internet Services. Enter the IP address of the device in your web
browser to access Internet Services.
12 Xerox ColorQube™ 9201/9202/9203
System Administrator Guide
on page 16.