Xerox ColorQube 9201 System Administrator Manual page 107

• Number of pages: *NONE
• Starting time: Time
• Ending time: Time
• Order of files on queue: *FIFO
• Remote system: *INTNETADR
• Remote printer queue: virtual printer name**
Note: The queue for ColorQube should be lp (lower case L and P).
• Writers to autostart: 1
• Queue for writer messages: QSYSOPR
• Library: *LIBL
• Connection type: *IP
• Destination type: *OTHER
• Transform SCS to ASCII: *YES
• Manufacturer type and model: *IBM42011 ***SEE NOTE BELOW***
• Workstation customizing object: xxxxxxxx (leave as default)
• Library: xxxxxxxx (leave as default)
• Internet address: xx.xxx.x.xx (IP address of printer)
• VM/MVS class: *SAME
• Forms control Buffer: *SAME
• Destination options: XAIX
• Text description
• Display any file: *NO
• Job separators: 0
• Operator controlled: *YES
Data Queue: *NONE
•
• Library:
• Authority to check: *DTAAUT
2. Press [Enter] to create.
Note: The Workstation Customizing Object is the file that was created in the
Description on page 98 step 2.
3. At this point, a spool file (document) should be able to be sent to the ColorQube device.
Note: If printing PCL, set this parameter to HPIIID, HP5Si (most of the HP drivers will work) and
set Workstation customizing object as *none.
If printing ASCII, set this parameter to *IBM42011 (which is the default).
Create a Device
Xerox ColorQube™ 9201/9202/9203
System Administrator Guide
Network Installation
99