2.
Click on the [Properties] tab.
3.
If prompted, enter the Administrator User ID and Password. The default is [admin] and [1111].
4.
Click on the [Login] button.
5.
Click on the [Services] link.
6.
Click on the [Printing] link.
7.
Select [General] in the directory tree.
8.
In the General area:
a.
for Configuration Report uncheck the [Print at power on] checkbox.
b.
Click on the [Apply] button to save your settings.
c.
Click on the [OK] button when you see the message "Properties have been successfully
modified".
To Restrict Configuration Report to System Administrator
You can restrict any printing of the Configuration Report to a logged-in System Administrator.
1.
At your Workstation, open the web browser and enter the IP address of the device in the Address
bar, and press [Enter].
2.
Click on the [Properties] tab.
3.
If prompted, enter the Administrator User ID and Password. The default is [admin] and [1111].
4.
Click on the [Login] button.
5.
Click on the [Services] link.
6.
Click on the [Printing] link.
7.
Select [General] in the directory tree.
In the General area:
8.
a.
For Configuration / Information Pages Report, check the [Restrict to SA] checkbox.
b.
Click on the [Apply] button to save you settings.
c.
Click on the [OK] button when you see the message "Properties have been successfully
modified".
Note:
If Configuration Report is restricted to System Administrator only, the Configuration button
in the Machine Information screen will be greyed out and will require you to log into the device to
access the Configuration Report.
Configure Print Protocols
1.
At your Workstation, open the web browser and enter the IP address of the device in the Address
bar, and press [Enter].
2.
At the Welcome page, click on the [Configure Device] button.
3.
If prompted, enter the Administrator User ID and Password. The default is [admin] and [1111].
4.
Click on the [Login] button.
5.
If you want to use the checklist, click on the [View Checklist] button and click on the [Print]
button. Scroll to the bottom of the screen and click on the [Close] button.
6.
Click on the [Settings] button next to Print Protocols.
7.
Click on the [Configure] button next to General Settings to configure general print settings.
Xerox ColorQube™ 9201/9202/9203
System Administrator Guide
General Setup
21