4.
Touch [Configuration Report].
5.
Touch [Print], then touch [Close].
If you want to disable automatic printing of a Configuration Report at Startup, refer to
Configuration Report to Print at Power On
Ethernet Configuration
Ethernet Port
The Ethernet Interface is set to auto detect the speed of your network. The device supports the
following selectable speeds:
•
Auto
•
10Mbps Half-Duplex
•
10Mbps Full-Duplex
•
100 Mbps Half-Duplex
•
100 Mbps Full-Duplex
•
1 Gbps Half-Duplex.
•
1 Gbps Full-Duplex
Note:
If your network has hubs that have Auto-Sensing enabled and the device Ethernet speed is
set to Auto, it is possible that the hub will not arbitrate to the correct speed.
Setting the Ethernet Speed at the Device
1.
Press the <Log In/Out> button to enter the Tools pathway.
2.
Enter the Administrator's User Name [admin], touch [Next], enter the Password [1111], then
touch [Enter].
3.
Press the <Machine Status> button.
4.
Touch [Tools].
5.
Touch [Network Settings].
6.
Touch [Advanced], if a warning message appears, touch [Continue].
7.
Touch [Ethernet Physical Media].
8.
Select the required Ethernet Physical Media speed to match the speed set on your hub or switch.
9.
Touch [Save], touch [Close].
10. Press the <Log In/Out> button.
11. Touch [Logout] to exit the Tools Pathway.
Enable TCP/IP and HTTP at the Device
Look at the Configuration Report, verify whether the addressing shown under TCP/IP Settings will
enable this device to communicate over your network. Also, verify that HTTP is enabled under HTTP
on page 20.
Xerox ColorQube™ 9201/9202/9203
Device Connection and Quick Setup
To Prevent the
System Administrator Guide
11