Cloning - Xerox ColorQube 9201 System Administrator Manual

15. Click on the [Save] button. You have finished configuring the protocol information, click on the
[Close] button.
16. To print to the device, install the Print Drivers on your workstation. If you need more information
refer to Print Drivers

Cloning

Cloning enables you to copy the settings and web generated scan templates of one device and transfer
them to other devices operating with the same version of system software. Depending on the optional
features installed on the device, groups of settings can be cloned. For example, scan settings will be
available for cloning only if the Workflow Scanning optional feature is already installed on the source
device.
After selecting the settings to be cloned, a configuration cloning file is created and saved with the
extension .dlm (downloadable module).
The configuration cloning file can then be submitted to other devices using Internet Services via a web
browser. The settings are transferred and applied to the recipient device.
Note: Optional features must be installed on the recipient device in order to accept cloned
settings. In other words, it is not possible to install an optional feature (for example, Workflow
Scanning or E-mail) through the process of cloning.
Cloning feature creates a .dlm file script that can be used to configure other devices. All devices
must have the same version of software for the .dlm file to be accepted.
To Verify the Software Version
1. At your Workstation, open the web browser and enter the IP address of the device in the Address
bar, and press [Enter].
2. Click on the [Properties] tab.
3. If prompted, enter the Administrator User ID and Password. The default is [admin] and [1111].
Click on the [Login] button.
4.
5. Click on the [General Setup] link.
6. Select [Configuration Report] in the directory tree.
7. Scroll down to the Software Versions area and view the System Software version.
To Clone a Device
1. At your Workstation, open the web browser and enter the IP address of the device in the Address
bar, and press [Enter].
2. Click on the [Properties] tab.
3. If prompted, enter the Administrator User ID and Password. The default is [admin] and [1111].
4. Click on the [Login] button.
5. Click on the [General Setup] link.
Select [Cloning] in the directory tree.
6.
7. In the Create Clone File area:
on page 107.
Xerox ColorQube™ 9201/9202/9203
System Administrator Guide
General Setup
23