Xerox ColorQube 9201 System Administrator Manual page 101

5. Click on the [Connectivity] link.
6. Click on the [Protocols] link.
7. Select [TCP/IP] in the directory tree.
8. Verify that the printing device has been configured with a static IP address (preferred), Subnet
Mask, Gateway Address, and Host Name.
9. Verify that the Domain Name for your network has been supplied, and that DNS is enabled and
configured to resolve Host Names to IP Addresses.
Note: Changing the device IP Address will impact other protocols: NetBIOS/IP, LPR/LPD, FTP,
SNMP and Raw TCP/IP Printing. These protocols will need to reference the new IP Address.
Disabling TCP/IP will impact other protocols: NetBIOS/IP, LPR/LPD, FTP, SNMP and Raw TCP/IP
Printing. This web user interface will be disabled until TCP/IP is reenabled from the local user
interface.
10. If any of the above items are incorrectly set, reset them and click on the [Apply] button.
11. Click on the [OK] button when you see the message "Properties have been successfully
modified".
12. Select [LPR/LPD] in the directory tree and verify that the Protocol is Enabled, and the Port
Number is set to 515.
Note: The settings are not applied until you restart the device.
13. Click on the [Status] tab, select [Description & Alerts] in the directory tree.
14. Click the [Reboot Machine] button and click [OK] to reboot the device. The network controller
takes approximately 5 minutes to reboot and network connectivity will be unavailable during this
time.
15. A Configuration Report should have printed by default when the device rebooted. Look at the
report to verify TCP/IP settings. If the Configuration Report did not print, go to the device:
Press the <Machine Status> button.
a.
b. Touch the [Machine Information] tab.
c. Touch [Information Pages].
d. Touch [Configuration Report].
e. Touch [Print], then touch [Close].
The Configuration Report will print, check under the Connectivity Protocol heading for TCP/IP
settings.
Select the PPD - PostScript® Printer Definition
1. Insert the Internet Services Print and Fax Drivers CD into your CD drive.
2. Double-click the printer icon on your desktop.
3. Select [Printing].
4. Select [Change Setup].
5. Select [Change].
6. Locate the [Drivers] folder on the CD.
7. Select the appropriate PPD for OS 10.x.
8. Select the options according to those installed on your device.
9. Click [OK].
Xerox ColorQube™ 9201/9202/9203
System Administrator Guide
Network Installation
93