Table of Contents
Advertisement
The PowerMax10-G2 display will revert to [33:CONFIRM TIME].
You can now press the
"
" or press the
DEFINE PANEL
4.7.8 Enable Alarm upon Detection of Jammed or Missing Device
Here you determine whether an alarm will be initiated (siren / report) when there is a supervision / jamming failure during
AWAY arming state.
Available options are: EN standard and other (default). When "EN standard" is selected, if there is supervision /
jamming failure during AWAY arming, the siren is activated and the events are reported as tamper events. When "Other"
is selected, there is no such activity during AWAY arming.
To Enable an Alarm Upon Detection of a Jammed or Missing Device
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
3.
Enter your Installer Code.
4.
Press the
option.
5.
When the PowerMax10-G2 display reads [DEFINE PANEL], press
The PowerMax10-G2 display will read [01:ENTRY DELAY 1].
When the PowerMax10-G2 display reads [01:ENTRY DELAY 1], press the
6.
or
[30:BELL/REP.OPT].
Press
and make the selection and then press
7.
I
OK
The PowerMax10-G2 display will revert to [30:BELL/REP.OPT].
You can now press the
"
" or press the
DEFINE PANEL
4.7.9 Configuring the Jamming Detection
Here you determine whether jamming (interfering transmissions, on the radio channel used by the system) will be detected
and reported or not.
If a jam detection option is selected, the system does not allow arming under the relevant jamming conditions.
Jam Detection Options
Option
Detection and Reporting when
UL 20/20
There is continuous 20 seconds of
(USA standard)
jamming
EN 30/60
There is an accumulated 30 seconds of
(Europe standard)
jamming within 60 sec.
class 6 (30/60)
Like EN (30/60) but the event will be
(British standard)
reported only if the jamming duration
exceeds 5 minutes.
Disable (default) (No jamming detection and reporting).
42
or
button to take you to "
or
button repeatedly and select the [DEFINE PANEL]
button
repeatedly
or
button to take you to "
button to program any other menu in
<OK> TO EXIT
until
the
display
to confirm.
I
OK
button to program any other menu in
<OK> TO EXIT
".
button
.
I
OK
I
OK
will
read
".
I
OK
33:CONFIRM TIME
READY 00:00
INSTALLER MODE
I
OK
ENTER CODE:
CODE
or
DEFINE PANEL
I
OK
01:ENTRY DELAY 1
or
30:BELL/REP.OPT
I
OK
SELECT OPTION
I
OK
30:BELL/REP.OPT
D-302756
Advertisement
Table of Contents
