About The Log File - Hitachi XP P9500 User Manual

#2
Specifying an invalid value causes an error.
For details on the settings functionality, see
Environment) on page
#3
You can specify this key only in the following cases:
¢
¢
#4
If you want to enable intermittent error monitoring, specify this key after
specifying the auto_failback and auto_failback_interval keys.
The following is an example of an installation-information settings file:
[INSTALLATION_SETTINGS]
installfile_location=/cdrom/cdrom0
logdir=/var/tmp
licensekeyfile=/var/tmp/hdlm_license
driver_config=y
restart=n
[ENVIRONMENT_SETTINGS]
load_balance=on
load_balance_type=exlio
error_log_level=3
error_log_size=9900
error_log_number=2
trace_level=0
trace_file_size=1000
trace_file_number=4
path_health_check=on
path_health_check_interval=30
auto_failback=on
auto_failback_interval=1
intermittent_error_monitor=on
intermittent_error_monitor_interval=30
intermittent_error_monitor_number=3

About the Log File

During an unattended installation, information about installation progress is
output to the log file installhdlm.log.
The following describes the installhdlm.log file:
6-16.
For a new installation:
When on is specified for the auto_failback key in the installation
information settings file
For an upgrade installation or re-installation:
When on is specified for the auto_failback key in the installation
information settings file, or when automatic failback is enabled in the
installation pre-settings
Utility Reference
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
set (Sets Up the Operating
7-35