Checking The Updated Settings - Hitachi XP P9500 User Manual

If you want to specify the output destination for audit log data, first specify
the audit log facility by using the dlnkmgr set -audfac command. Next,
define the output destination of the facility in the /etc/syslog.conf file.
Table 3-62 Values Indicating Audit Log Facility on page 3-192
values that indicate audit log facility. The default is user.
user or 1
local0 or 16
local1 or 17
local2 or 18
local3 or 19
local4 or 20
local5 or 21
local6 or 22
local7 or 23
This example shows how to specify the audit log facility:
# /opt/DynamicLinkManager/bin/dlnkmgr set -audfac local0

Checking the Updated Settings

This chapter describes steps involved in how to check the new settings by
using the dlnkmgr command's set operation after the new settings are
applied.
When you some these settings, you can display information about all of HDLM
function settings. The following is an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -sfunc
HDLM Version
Service Pack Version
Load Balance
Support Cluster
Elog Level
Elog File Size(KB)
Number Of Elog Files
Trace Level
Trace File Size(KB)
Number Of Trace Files
Path Health Checking
Auto Failback
Reservation Status
Intermittent Error Monitor
KAPL01001-I The HDLM command completed normally. Operation name =
3-192
Table 3-62 Values Indicating Audit Log Facility
Value Corresponding facility value in the /etc/syslog.conf file
user
local0
local1
local2
local3
local4
local5
local6
local7
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Linux(R))
: x.x.x-xx
:
: on(extended lio)
:
: 2
: 1000
: 5
: 1
: 2000
: 10
: on(10)
: on(10)
:
: on(2/20)
describes the