Cabling Procedure For Mvp-410St/810St - Multitech MULTIVOIP MVP-2410 User Manual

Mechanical Installation & Cabling

Cabling Procedure for MVP-410ST/810ST

Cabling involves connecting the MultiVOIP to your LAN and telephone
equipment.
1. Connect the power cord supplied with your MultiVOIP to a live AC
outlet and to the power connector on the back of the MultiVOIP as
shown at top right in Figure 3-14.
IS DN 1
ISDN1 & ISDN 2 : MVP41 0ST/8 10ST
ISDN3 & ISDN 4: MVP81 0ST only
TERMINAL
MODE
*
PSTN
PBX
* NT1 Device is needed
if PBX has "U" interface.
2. Connect the MultiVOIP to a PC by using a DB-25 (male) to DB-9
(female) cable. Plug the DB-25 end of the cable into the Command
port of the MultiVOIP and the other end into the PC serial port. See
Figure 3-14.
3. Connect a network cable to the ETHERNET 10BASET connector on
the back of the MultiVOIP. Connect the other end of the cable to your
network.
Command Modem/TA connector
for remote configuration
ISD N2 IS DN 3 ISD N4 CO MMAN D
MOD EM
ISDN-B RI Conne ctions
?
NET WORK
MODE
ISDN
TA
NT1
Device
Figure 3-14: Cabling for MVP-410ST/810ST
MultiVOIP User Guide
ET H ER NE T
CO MMAN D
10 B AS E T
Command Port Connection
100
Ethernet Connection