Cabling Your Multivoip 200; Cabling Procedure - Multitech MultiVOIP 100 MVP110 Quick Start Manual

Cabling Your MultiVOIP 110
Cabling your MultiVOIP 110 involves making the proper
Power, Command Port, and Internet connections. Figure 6
shows the back panel connectors and the associated cable
connections. The Cabling Procedure section provides step-by-
step instructions for cabling your MultiVOIP 110.

Cabling Procedure

1. Using the supplied cable, connect the power supply to a
live AC outlet, then plug the power supply into the
MultiVOIP 110 as shown in Figure 3.
Figure 3. Cable Connections
2. Connect the MultiVOIP 110 to a PC using the RJ-45 to
DB9 (female) cable provided with your unit. Plug the RJ-45
end of the cable into the Command port of the MultiVOIP
110 and connect the other end to the PC's serial port
(Figure 3).
3. Connect a network cable to the Ethernet 10Base-T
connector on the back of the MultiVOIP 110. Connect the
other end of the cable to your network.
4. If you are connecting a station device such as an analog
Cabling
9