Cabling Procedure For Mvp210 - Multitech MULTIVOIP MVP-2410 User Manual

Voice over ip gateways

Hide thumbs Also See for MULTIVOIP MVP-2410:

Table of Contents

Mechanical Installation & Cabling

Cabling Procedure for MVP210

Cabling involves connecting the MultiVOIP to your LAN and telephone

For DID channels only

will be using either FXS, FXO, or E&M telephony interfaces, skip to

For any channel on which you are using the DID interface type, you

must change the jumper on the MultiVOIP circuit card.

a. Disconnect power. Unplug the AC power cord from the wall outlet

or from the receptacle on the MultiVOIP unit.

b. Using a #1 Phillips driver, remove the screw (at bottom of unit,

near the back-cover end) that attaches the main circuit card to the

chassis of the MVP210.

c. Pull the main circuit card out about half way.

. If both channels of your MVP210 MultiVOIP

MultiVOIP User Guide