Multitech MULTIVOIP MVP-2410 User Manual page 256

Technical Configuration (Analog/BRI)
Field Name
Interface
Type
Mode
Signal
Wink Timer
(in ms)
Pass Through
Enable
E&M Interface Parameter Definitions
*Not applicable to MVP130FXS
Values
E&M
Types 1-5.
2-wire or 4-wire
Dial Tone or
Wink
integer values,
in milliseconds
Y/N
256
MultiVOIP User Guide
Description
enables E&M functionality
Refers to the type of E&M
interface being used.
Each E&M interface type can be
either 2-wire or 4-wire audio.
When Dial Tone is selected, no
wink is required on the E lead
or M lead in the call initiation or
setup.
When Wink is selected, a wink
is required during call setup.
This is the length of the wink
for wink signaling.
Applicable only when Signal
parameter is set to "Wink."
When enabled ("Y"), this
feature is used to create an open
audio path for 2- or 4-wire. The
E&M leads are passed through
the voip transparently.
Applicable only for E&M
Signaling with Dial Tone.