Placement; The Command/Control Computer (Specs & Settings) - Multitech MULTIVOIP MVP-2410 User Manual

MultiVOIP User Guide

Placement

Mount your MultiVOIP in a safe and convenient location where cables
for your network and phone system are accessible. Rack-mounting
instructions are in Chapter 3: Mechanical Installation & Cabling.
The Command/Control Computer (Specs & Settings)
The computer used for command and control of the MultiVOIP
(a) must be an IBM-compatible PC,
(b) must use a Microsoft operating system,
(c) must be connected to your local network (Ethernet) system, and
(d) must have an available serial COM port.
The configuration tasks and control tasks the PC will have to do with
the MultiVOIP are not especially demanding. Still, we recommend
using a reasonably new computer. The computer that you use to
configure your MultiVOIP need not be dedicated to the MultiVOIP
after installation is complete.
COM port on controller PC. You'll need an available COM port on the
controller PC. You'll need to know which COM port is available for use
with the MultiVOIP (COM1, COM2, etc.).
Quick Start Instructions
51