Multitech MULTIVOIP MVP-2410 User Manual page 96

Mechanical Installation & Cabling
d. Identify the channels on which the DID interface will be used.
Upper Circuit Card
MVP810 only
Ch 7
Ch 5 Ch 6
U7 U9
Ch 1
Ch 2
Figure 3-11. MVP-410/810 Channel Jumper Settings
e. Position the jumper for each DID channel so that it does not connect
the two jumper posts. For DID operation of a voip channel, the
MultiVOIP will work properly if you simply remove the jumper
altogether, but that is inadviseable because the jumper might be
needed later if a different telephony interface is used for that voip
channel.
f. Slide the main circuit card back into the MultiVOIP chassis and
replace the three screws.
Ch 8
U10
U8
Jumpers 5-8
}
Main Circuit Card
MVP-410/810
Ch 3 Ch 4
}
Jumpers 1-4
MultiVOIP User Guide
Jumper Configurations
(enlarged)
Generality:
For channels using the DID
interface, the jumper must
not straddle across the
cross-hatched area between
the jumper posts.
For channels using any non-DID
interface, it is acceptable that the
jumper straddles across the
cross-hatched area between
the jumper posts.
96
For DID
Interface type
For non-DID
Interface type