Installation Instructions For Mvp428 Upgrade Card - Multitech MULTIVOIP MVP-2410 User Manual

MultiVOIP User Guide

Installation Instructions for MVP428 Upgrade Card

In this procedure, you will install an additional circuit board into the MVP410,
converting it from a 4-channel voip to an 8-channel voip.
Summary
(A)
Replace main card screws
with standoffs here
(2 places).
Add standoffs here
(2 places).
Figure D-1. Installation Summary
Procedure in Detail
1. Power down and unplug the MVP410 unit.
2. Using a Phillips driver, remove the blank cover plate at the rear of the
MVP410 chassis. Save the screws.
Figure D-2: Removing screws from blank cover plate
: (A) Attach four standoffs to main circuit card.
(B) Mate the 60-pin connectors (male connector
on main circuit card; female on upgrade card).
(C) Attach upgrade card to main circuit card (4
screws).
*
*
screws on blank cover plate (2)
511
8-Channel Analog Expansion Card
Attach upgrade card
(screws into standoffs
(B)
Mate 60-pin
connectors.
*
(C)
-- 4 places).