Phone/Ip Starter Configuration - Multitech MULTIVOIP MVP-2410 User Manual

MultiVOIP User Guide

Phone/IP Starter Configuration

Full details here:
MVP2410
MVP3010
MVP130
MVP130FXS
MVP210
MVP410
MVP810
1. Open MultiVOIP program: Start | MultiVOIP xxx | Configuration.
2. Go to Configuration | IP. Enter the IP parameters for your voip site.
3. Do you want to configure and operate the MultiVOIP unit using the
web browser GUI? (It has the same functionality as the local
Windows GUI, but offers remote access.)
If NO, skip to step 5.
If YES, continue with step 4.
4. Enable Web Browser GUI (Optional). To do configuration and
operation procedures using the web browser GUI, you must first
enable it. To do so, follow these steps. (The browser used must be
Internet Explorer 6.0 or above; or Netscape 6.0 or above.)
A. Be sure an IP address has
been assigned to the
MultiVOIP unit (this must be
done in the MultiVOIP
Windows GUI).
B. Save Setup in Windows GUI.
C. Close the MultiVOIP
Windows GUI.
D. Install Java program from
MultiVOIP product CD.
(Must be Java Runtime
Environment 1.4.2_01 or above.)
NOTE: Required on first use of
Web Browser GUI only.
Need more
info?
Chapter 5: Technical Configuration for
Digital T1/E1 MultiVOIPs
in User Guide.
Chapter 6: Technical Configuration for
Analog/BRI MultiVOIPs
in User Guide
See "Web Browser Interface" in Operation &
Maintenance chapter of
59
Quick Start Instructions
E. Open web browser.
(Note: The PC being used must
be connected to and have an IP
address on the same IP network
that the voip is on.)
F. Browse to IP address of
MultiVOIP unit.
G. If username and password
have been established, enter
them when prompted by
voip.
H. Use web browser GUI to
configure or operate voip.
(on CD).
User Guide