Multitech MULTIVOIP MVP-2410 User Manual page 259

Voice over ip gateways

Hide thumbs Also See for MULTIVOIP MVP-2410:

Table of Contents

MultiVOIP User Guide

DID Parameters. The parameters applicable to the Direct Inward Dial

(DID) telephony interface type are shown in the figure below and

described in the table that follows. The DID interface allows one phone

line to direct incoming calls to any one of several extensions without a

switchboard operator. Of course, one DID line can handle only one call

at a time. The parameters described here pertain to the customer-

premises side of the DID connection (DID-DPO, dial-pulse originating);

the network side of the DID connection (DID-DPT, dial-pulse

terminating) is not supported.

Technical Configuration (Analog/BRI)

DID Interface Parameter Definitions

*Not applicable to MVP130FXS

Immediate Start,

Enables the customer-premises

side of DID functionality

MultiVOIP's use of DID applies

only for incoming DID calls.

The Start Mode used by the

MultiVOIP must match that

used by the originating

telephony equipment, else DID

calls cannot be completed.

For Immediate Start, the voip

detects the off-hook condition

initiated by the telco central-

office call and becomes ready to

receive dial digits immediately.