Multitech MULTIVOIP MVP-2410 User Manual page 145

MultiVOIP User Guide
Coder Parameters
Coder
Selected
Coder
Max
bandwidth
(coder)
Voice/Fax Parameter Definitions (cont'd)
Manual or Determines whether selection of
Auto- coder is manual or automatic.
matic When Automatic is selected, the
local and remote voice channels will
negotiate the voice coder to be used
by selecting the highest bandwidth
coder supported by both sides
without exceeding the Max
Bandwidth setting. G.723, G.729, or
G.711 are negotiated.
G.711 a/u Select from a range of coders with
law 64 specific bandwidths. The higher the
kbps; bps rate, the more bandwidth is
G.726, @ used. The channel that you are
16/24/32
calling must have the same voice
/40 kbps; coder selected.
G.727, @
nine bps Default = G.723.1 @ 6.3 kbps, as
rates; required for H.323. Here 64K of
G.723.1 @ digital voice are compressed to
5.3 kbps, 6.3K, allowing several simultaneous
6.3 kbps; conversations over the same
G.729, bandwidth that would otherwise
8kbps; carry only one.
Net Coder
@
To make selections from the
6.4, 7.2, 8, Selected Coder drop-down list, the
8.8, 9.6 Manual option must be enabled.
kbps
11 – 128 This drop-down list enables you to
kbps select the maximum bandwidth
allowed for this channel. The Max
Bandwidth drop-down list is
enabled only if the Coder is set to
Automatic.
If coder selected automatically, then
enter a value for maximum
bandwidth, as directed by VOIP
administrator.
145
Technical Configuration (T1/E1)