8-Channel Analog Expansion Card
3. Using a Phillips driver, remove the three screws that secure the main circuit
board and back panel assembly to the chassis.
back panel screws (3)
4. Slide the main circuit board out of the chassis far enough to unplug the
power connector.
5. Unplug the power connector from the main circuit board.
6. Slide the main circuit board completely out of the chassis and place on a
non-conductive, static-safe tabletop surface.
7. Remove mounting hardware (2 screws, 2 nuts, and 4 standoffs) from its
package.
Follow standard ESD
precautions to protect the
circuit board from static
electricity damage.
Figure D-3: Removing screws from back panel
Figure D-4: Accessing power connector
512
MultiVOIP User Guide
NOTE:
power connector