Multitech MULTIVOIP MVP-2410 User Manual page 151

MultiVOIP User Guide
Field Name
Auto Disconnect
Jitter Value
Call
Duration
Consecutive
Packets Lost
Network
Discon-
nection
Voice/Fax Parameter Definitions (cont'd) )
Values
Parameters
1-65535
milli-
seconds
1-65535
seconds
1-65535
1 to 65535
seconds;
Default =
300 sec.
Technical Configuration (T1/E1)
Description
The Automatic Disconnection
group has four options which can
be used singly or in any
combination.
The Jitter Value defines the average
inter-arrival packet deviation (in
milliseconds) before the call is
automatically disconnected. The
default is 150 milliseconds. A higher
value means voice transmission will
be more accepting of jitter. A lower
value is less tolerant of jitter.
Inactive by default. When active,
default = 150 ms. However, value
must equal or exceed Dynamic
Minimum Jitter Value.
Call Duration defines the
maximum length of time (in
seconds) that a call remains
connected before the call is
automatically disconnected.
Inactive by default.
When active, default = 180 sec.
This may be too short for most
configurations requiring upward
adjustment.
Consecutive Packets Lost defines
the number of consecutive packets
that are lost after which the call is
automatically disconnected.
Inactive by default.
When active, default = 30
Specifies how long to wait before
disconnecting the call when IP
network connectivity with the
remote site has been lost.
151