Multitech MULTIVOIP MVP-2410 User Manual page 105

MultiVOIP User Guide
d. Identify the channels on which the DID interface will be used.
e. Position the jumper for each DID channel so that it does not connect
the two jumper posts. For DID operation of a voip channel, the
MultiVOIP will work properly if you simply remove the jumper
altogether, but that is inadviseable because the jumper might be
needed later if a different telephony interface is used for that voip
channel.
f. Slide the main circuit card back into the MultiVOIP chassis and
replace the screw at the bottom of the unit.
2. Connect the power cord supplied with your MultiVOIP to the power
connector on the back of the MultiVOIP and to a live AC outlet as
shown in Figure 3-17.
L E D1 4 L E D1 2
L ED1 3 L E D11 L E D10 LE D9 LE D8
R 113 R 7 2
R 114 R 58 R 57 R 56 R 5 5
MVP210 Circuit Board
Ch1
Ch2
J3
J 7
J5 J9
Figure 3-16. MVP210 Channel Jumper Settings
105
Mechanical Installation & Cabling
L E D7
L ED6 LE D5 LE D4 LE D3
R74
R 2 05
as configured
for DID Interface
JP4
Ch 1 Jumper
Block
P7
JP7
as shipped,
for non-DID interfaces
JP8
Ch 2 Jumper
JP1
Block
J 11
J1
as configured
for DID Interface
L E D2 L E D1
R 2
F B3
S 1 0
J 15