Connectivity Test - Multitech MULTIVOIP MVP-2410 User Manual

Quick Start Instructions

Connectivity Test

The procedures "Phone/IP Starter Configuration" and "Phonebook
Starter Configuration" must be completed before you can do this
procedure.
1. These connections must be made:
for digital MultiVOIPs
(MVP-2410/3010)
MultiVOIP to local PBX
MultiVOIP to command PC
MultiVOIP to Internet
2. Inbound Phonebook and Outbound Phonebook must both be set up
with at least one entry in each. These entries must allow for
connection between two voip units.
3. Console messages must be enabled. (If this has not been done
already, go, in the MultiVOIP GUI, to Configuration | Logs and
select the "Console Messages" checkbox.
4. You now need to free up the COM port connection (currently being
used by the MultiVOIP program) so that the HyperTerminal program
can use it. To do this, you can either (a) click on Connection in the
sidebar and select "Disconnect" from the drop-down box, or (b) close
down the MultiVOIP program altogether.
Connections
for analog MultiVOIPs
(MVP-130/130FXS
& MVP-210/410/810)
MultiVOIP to local phone
station
–OR--
MultiVOIP to extension of
key phone system
MultiVOIP to command PC
MultiVOIP to Internet
78
MultiVOIP User Guide