Multitech MULTIVOIP MVP-2410 User Manual page 278

Technical Configuration (Analog/BRI)
The Custom Tone-Pair Settings fields are described in the table below.
Field Name
Tone Pair
TONE PAIR VALUES
Frequency 1
Frequency 2
Gain 1
Gain 2
Custom Tone-Pair Settings Definitions
Values
dial tone,
busy tone,
ring tone,
'unobtainable'
tone,
survivability
tone,
re-order tone
frequency in
Hertz
frequency in
Hertz
gain in dB
+3dB to –31dB
and "mute"
setting
gain in dB
+3dB to –31dB
and "mute"
setting
278
MultiVOIP User Guide
Description
Identifies the type of telephony
signaling tone for which
frequencies are being specified.
About Defaults: US telephony
values are used as defaults on
this screen. However, since this
dialog box is provided to allow
custom tone-pair settings,
default values are essentially
irrelevant.
Frequency of lower tone of pair.
This outbound tone pair enters
the MultiVOIP at the input port.
Frequency of higher tone of pair.
This outbound tone pair enters
the MultiVOIP at the input port.
Amplification factor of lower
frequency of pair. This figure
describes amplification that the
MultiVOIP applies to outbound
tones entering the MultiVOIP at
the input port. Default = -16dB
Amplification factor of higher
frequency of pair. This figure
describes amplification that the
MultiVOIP applies to outbound
tones entering the MultiVOIP at
the input port. Default = -16dB