Analog Telephony Interface Parameters (For Mvp-130/130Fxs/210/410/810) - Multitech MULTIVOIP MVP-2410 User Manual

Voice over ip gateways

Hide thumbs Also See for MULTIVOIP MVP-2410:

Table of Contents

MultiVOIP User Guide

Write down the values for these IP parameters. You will need to enter

these values in the "IP Parameters" screen in the Configuration section

of the MultiVOIP software. You must have this IP information about

every VOIP in the system.

Analog Telephony Interface Parameters

(for MVP-130/130FXS/210/410/810)

The following parameters must be known about the PBX or telco

central office equipment to which the analog MultiVOIP will connect:

Analog Phone Parameters

Ask phone company or

telecom manager.

• Which interface type (or "signaling") is used?

• If FXS, determine whether the line will be used for a

• If FXO, determine if line will be an analog PBX

• If E&M, determine these aspects of the E&M trunk

Analog Telephony Interface Parameters:

Record for this VOIP Site

phone, fax, or KTS (key telephone system)

extension or an analog line from a telco central office

line from the PBX:

• What is its Type (1, 2, 3, 4, or 5)?

• Is it 2-wire or 4-wire?

• Is it Dial Tone or Wink?

Technical Configuration (Analog/BRI)