Cabling Your Multivoip; Cabling Procedure - Multitech MVP200 Quick Start Manual

Cabling Your MultiVOIP

Cabling your MultiVOIP involves making the proper Power,
Command Port, phone system, and Internet connections.
Figure 5 shows the back panel connectors and the associated
cable connections. The following paragraph details the steps
necessary for cabling your MultiVOIP.
Note: Before starting to cable your MultiVOIP, perform the
E&M Jumper Block Positioning Procedure if either voice/
fax channel (1 or 2) will be connected to an E&M trunk that
is a Type 1,3,4, or 5 rather than a Type 2 (the default).

Cabling Procedure

1 Connect the power supply to a live AC outlet, then
connect it to the MultiVOIP as shown in Figure 5. The
power connector is a 7-pin circular DIN connector.
PSTN
2 Connect the MultiVOIP to a PC using the RJ-45 to DB9
(female) cable provided with your unit. Plug the RJ-45 end
of the cable into the Command port of the MultiVOIP and
connect the other end to the PC serial port you're using.
See Figure 5.
Voice/Fax Channel 1 Voice/Fax Channel 2
E&M FXS FXO FXO FXS E&M
Voice/Fax Channel
1 & 2 Connections
E&M FXO
FXS
PBX
Figure 5. Cable Connections
Ethernet RS232
1
0
10Base-T Command Power
Cabling
Power Connection
Command Port Connection
Network Connection
Hub
11