System Speed Dial Codes - Lucent Technologies MERLIN LEGEND Release 5.0 System Planning Manual

MERLIN LEGEND Communications System Release 5.0
System Planning 555-650-112
5 Data Communications
Assigning Features to Data Stations
Planning Form Instructions
1. Using Form 3f, Automatic Route Selection Tables and Form 3g, Automatic
Route Selection Default and Special Numbers Table, review the values
assigned to the routes.
2. In the Optional Features section of Data Form 1a or 1b for each data
station to record your decisions about Facility Restriction Level, do one of
the following:

System Speed Dial Codes

To avoid giving the telephone number of a remote computer to modem pool
users, assign a System Speed Dial code to the telephone number. Users can dial
this 3-digit code to place data calls to the remote computer.
For data calls, the telephone number programmed for a System Speed Dial code
must include the access code (the dial-out code or the ARS dial-out code) if
required.
To specify that the remote computer's telephone number does not appear on call
reports, use the System Speed Dial instructions in
Check 3 to keep the factory setting.
Write the value (0 to 6) for the ARS Facility Restriction level you
want to assign to each data station.
5
Chapter 4 of this book.
Issue 1
June 1997
Page 5-40