Lucent Technologies MERLIN LEGEND Release 5.0 System Planning Manual page 72

MERLIN LEGEND Communications System Release 5.0
System Planning 555-650-112
2 Control Unit Configuration
Numbering the System
from ports 2, 3, 4, 6, 7, or 8 (the CTI Link port cannot be the potential operator port
or the console programming port).
Planning Form Instructions
Use the floor plan and Equipment List (if available) to verify that you have located
any video stations and all remaining MLX telephones and adjuncts connected to
them.
1. On Form 2a, mark the extension jack assignments for the video stations
and the remaining MLX telephones:
2. Using the information from Form 2a, mark the digital extension adjuncts
and video stations on Form 2b, System Numbering: Digital Adjuncts:
In the Jack Type column, make sure D is checked next to the logical
ID for each digital extension jack.
In the Person, Location, or Function column, identify each video
station or MLX telephone by the users name, location, or function.
If an extension port will be a CTI link, Write CTI Link in the Person,
Location, or Function column, and Label column, and put a check
mark in the CTI Link column. If this is a CTI link, skip to Step 3. The
CTI Link port must be selected from ports 2, 3, 4, 6, 7, or 8 (the CTI
Link port cannot be the potential operator port or the console
programming port).
Do one of the following:
— If the jack does not have an adjunct connected, write None in
the Adjuncts column and skip to Step 3.
— If an adjunct is connected to the MLX telephone, proceed to
Step b.
If an adjunct is connected to the MLX telephone, enter the type of
adjunct (such as MFM-SAA, MFM-T/R, ER1000, or 7500B) in the
Adjuncts column.
If a digital data or video station will be connected to the jack, and the
equipment supports 2B Data (such as a videoconferencing system
using a BRI interface or a v.35 interface and an ISDN terminal
adapter that supports 2B Data), check the box in the 2B column.
NOTE:
Do not connect equipment that does not support 2B Data (such as
G4 FAX, or a videoconferencing system using a v.35 interface and
an ISDN terminal adapter that does not support 2B Data) to an MLX
jack configured as a 2B Data port.
Issue 1
June 1997
Page 2-22