Lucent Technologies MERLIN LEGEND Release 5.0 System Planning Manual page 168

MERLIN LEGEND Communications System Release 5.0
System Planning 555-650-112
4 Features
Group-Assigned Features
Under the Delay Ring Interval heading, do one of the following:
3.
4. On Form 7c:
a.
b.
c.
NOTES:
1. If you have not yet created calling groups, you must defer naming them as
receivers until later.
2. If the system includes a voice mail system, see that system's
documentation for completing the receivers.
5. On each copy of Forms 4b, 4d, 5a and 5b that describes a specific
receiver:
a.
b.
To keep the factory-set interval, check the 2 rings box.
To change the factory-set interval, check the second box and write
the number of rings (1 to 6) in the space provided.
Write the group number in the Group No. space. Start with
number the groups sequentially.
NOTE:
If a group is the coverage group for AUDIX Voice Power (the factory
setting is Group No. 30 but can be changed), write
group number and list the extensions of AUDIX Voice Power
subscribers (see Form 2a).
List the extension numbers of all senders in the group in the upper
block (see Form 2a).
List the receivers for the group in the lower block by doing one of the
following:
Designate a calling group as a receiver by checking the Calling
Group box (see Form 7d).
Designate the QCC queue as a receiver (Hybrid/PBX mode only) by
checking the QCC Queue box and/or listing the extension numbers
of all receivers (maximum of eight).
Locate an available button on the Button Diagram.
Write Group Cover and the coverage group number in the space
available.
Issue 1
June 1997
Page 4-26
1 and
AUDIX by the