Lucent Technologies MERLIN LEGEND Release 5.0 System Planning Manual page 163

MERLIN LEGEND Communications System Release 5.0
System Planning 555-650-112
4 Features
Operator Features
If two DSSs are connected, set each Page button for a range of 100
numbers. The Page buttons then control 100 extensions, 50 on each DSS.
NOTE: NOTE: NOTE:
If two DSSs are used, the Page buttons on the second selector are not
active.
Planning Form Instructions
In the Page Buttons table under the Direct Station Selector heading of Form 6a
(page 1), write the beginning extension for the range of the 50 or 100 extension
numbers for each Page button. Assign the lowest extension numbers in the plan
to the first Page button, the middle range of numbers to the second Page button,
and the highest extension numbers to the third Page button. (Use the information
from Form 2a, System Numbering: Extension Jacks to assign the range of
extensions for each Page button.) Also, record this information on Form 2d under
the DSS Page Buttons heading.
Park Zones
This section contains instructions to enable operators with a DSS to have
one-touch use of Park, that is, to put calls into a special type of hold so that the
calls can be picked up from any telephone in the system. The system
automatically reserves eight extensions (881 888) for system operator park
zones; only system operators can use these park zone extensions to park calls.
Consider changing these factory-set extensions to numbers that fall within the
Page button ranges. The same considerations apply as those used during
reassignment of extension numbers.
Planning Form Instructions
In the Call Park Codes table under the Direct Station Selector heading on
Form 6a:
Write the new Zone numbers assigned in the Renumber to columns.
On Form 2d, System Numbering: Special Renumbers, write the new
numbers in the Renumber to column of the Park Zone section of that form.
Issue 1
June 1997
Page 4-21