Hotline - Lucent Technologies MERLIN LEGEND Release 5.0 System Planning Manual

MERLIN LEGEND Communications System Release 5.0
System Planning 555-650-112
4 Features
Telephone and Extension Features
To allow an extension to complete trunk-to-trunk transfers, check the Yes
box.

HotLine

The HotLine feature is available only for single-line telephones and devices
connected to a port on an 008 OPT, 012, or 016 module. A single-line telephone
connnected to an MFM cannot use the HotLine feature. This feature enables you
to set up a telephone to dial one specific number once the telephone goes
off-hook. The number that is dialed is the first personal speed dial (code 01)
programmed on the single-line telephone using centralized telephone
programming or extension programming. (Extension programming is only
available before the HotLine feature is activated.)
Planning Form Instructions
On Form 4f specify if this device will use the HotLine Feature. Under the HotLine
heading on Form 4f, do one of the following:
To set the extension to not use the HotLine feature, check the Off (factory
setting) box.
To set the extension to be a HotLine extension, check the On box. Enter
the extension or telephone number that the HotLine extension dials when it
is taken off-hook in the space provided below the On box.
4
Issue 1
June 1997
Page 4-8