Fax Message-Waiting Receiver; Trunk-To-Trunk Transfer - Lucent Technologies MERLIN LEGEND Release 5.0 System Planning Manual

MERLIN LEGEND Communications System Release 5.0
System Planning 555-650-112
4 Features
Telephone and Extension Features

Fax Message-Waiting Receiver

Use these instructions only when the system has fax machines connected directly
to the control unit by way of an 008 OPT, 016, or 012 module or connected to an
MLX telephone using a Multi-Function Module (MFM). Otherwise, skip to the next
section, ''Operator
Fax machines cannot use General-Purpose Adapters (GPAs) because they
cannot auto dial through the GPA.
This section contains instructions to designate from one to four telephones to
receive message-waiting indications when a fax is received on a specific fax
machine, and to specify the length of time before the system assumes a fax has
arrived and sends the message-waiting indication.
Planning Form Instructions
Use Form 6d to identify up to 16 fax machine extension numbers and up to four
receiver extension numbers for each fax number.
The System Notification Threshold setting can be left at the factory default of 10
seconds or be changed and identified on the line at the top of the form for up to 30
seconds.
NOTE: NOTE: NOTE:
You will fill in the rest of the optional telephone features later.

Trunk-to-Trunk Transfer

This section contains instructions to allow or disallow trunk-to-trunk transfer at
each extension.
Trunk-to-trunk transfer may only be performed on ground-start trunks and
loop-start trunks with reliable disconnect. As of Release 4.0, trunk-to-trunk
transfer may be performed on BRI, Tie lines, PRI, ground-start trunks, and
loop-start trunks that have reliable disconnect.
Trunk-to-trunk transfer is defaulted disabled, it may be enabled for a specific
extension. Single-line telephones are restricted from completing a trunk-to-trunk
transfer.
Planning Form Instructions
Use Form 6b to identify extensions permitted to perform trunk-to-trunk transfers.
Under the Trunk-to-Trunk Transfer heading on Form 6b, do one of the following:
To block an extension from completing a trunk-to-trunk transfer, check the
No (factory setting) box.
Features''.
4
4
Issue 1
June 1997
Page 4-7