Rotary; Allowed Lists - Lucent Technologies MERLIN LEGEND Release 5.0 System Planning Manual

MERLIN LEGEND Communications System Release 5.0
System Planning 555-650-112
4 Features
System Features
Planning Form Instructions
Under the Recall Timer heading on Form 8a, check one of the following:
350 ms
450 ms (factory setting)
650 ms
1 sec

Rotary

This section contains instructions for designating whether dialed digits on
rotary-dial lines/trunks are sent one by one as they are dialed or are stored and
sent when dialing is completed.
Planning Form Instructions
Under the Rotary heading on Form 8a, check one of the following:
To store digits and send them when dialing is completed, check the Delay
(factory setting) box.
To send digits out as they are dialed, check the No Delay box.

Allowed Lists

!
SecurityAlert:
If you assign a 0 (zero) as the first digit for any entry in an Allowed List, any
toll restrictions assigned for calls to numbers that can be placed by local or
toll operators are removed.
Use the instructions in this section and the next
restrictions are assigned to any telephones. Otherwise, skip to the section,
Service''.
This section contains instructions to designate an Allowed List of telephone
numbers that a restricted telephone can dial.
You can design up to 8 lists, each with a maximum of 10 numbers. Each number
can have up to 6 digits, for example, an area code followed by an exchange. If a
toll-call prefix is required, you can include a leading 1, which the system doesn't
count as one of the 6 digits. Star codes (such as *67) may also be included in the
list to allow users to access special services offered by the Central Office (CO).
Once you have designed the lists, decide which restricted telephones have
access to the lists. Each restricted telephone can have up to 8 lists.
4
4
(''Disallowed Lists'') only if calling
Issue 1
June 1997
Page 4-42
''Night