Lucent Technologies MERLIN LEGEND Release 5.0 System Planning Manual page 296

MERLIN LEGEND Communications System Release 5.0
System Planning 555-650-112
D T1/PRI Planner
NTM also evaluates the complexity of the facility configuration requested. Exam-
ples of complex configurations are connections into PBX networking applications,
connections to multiplexing arrangements, or applications that involve customer
engineering or design. NTM then does one of the following:
If an order is considered complex, NTM directs you to the Business Com-
munications System (BCS) National Engineering Center (NEC).
If NTM notifies you that the order's configuration is not complex, Tier Ill Gen-
eral Business System (GBS) National Technical Service Center (NTSC) is
authorized to approve the configuration.
The NTSC group's preauthorization review is based, in part, on information you
provide to them. Specifically, you must send them the following:
A copy of the planner
A completed "Non-Complex Configuration" sheet (pages 5 through 10 of the
Planner) for each 100D module you plan to install
Complete one Non-Complex Configuration page (pages 5 through 10) for each
100D module. Label the top right corner of the copies "Page 1 of _ " (1, 2, or 3). On
each page:
1. Write the module number (1, 2, or 3). Indicate the total number of 100D
modules (maximum of 3 for each system).
2. Fill in the control unit slot number (refer to page 1 of Form 3b).
3. In the Services section:
a. Check the box next to each emulated trunk or service that will be con-
b. Circle the channel(s) to which each emulated trunk or service will be as-
NOTE:
No channel should show more than one trunk or service, and the 24th chan-
nel cannot be used if the signaling type is common channel.
nected. Check only those services allowed on the type of service (T1,
AT&T Toll, MCI Toll, or DMS Local) selected for the module.
signed.
Issue 1
June 1997
Page D-6