Outmode Signaling - Lucent Technologies MERLIN LEGEND Release 5.0 System Planning Manual
Communications system
Hide thumbs
Also See for MERLIN LEGEND Release 5.0:
- System programming manual (949 pages) ,
- Feature reference (869 pages) ,
- Maintenance and troubleshooting manual (468 pages)
Table of Contents
Advertisement
MERLIN LEGEND Communications System Release 5.0
System Planning 555-650-112
3
Lines/Trunks
Selecting Line/Trunk Options
Before you change the setting, check with the telephone company to determine
whether the disconnect signals for the loop-start trunks are reliable and to obtain
the length of the hold disconnect interval.
If you select Reliable disconnect, you can set the interval after which the line/trunk
is released as described in "Hold Disconnect Interval" later in this section.
Trunk-to-trunk transfer is administered on a per-extension basis and may be
disabled even if the loop-start trunk has reliable disconnect. See the
''Trunk-to-Trunk Transfer''
Planning Form Instructions
At the top of Form 2c, under the Loop-Start Reliable Disconnect heading, choose
one of the following:
If the loop-start trunks have an unreliable disconnect signal, check the No
box (the factory setting).
If the loop-start trunks have a reliable disconnect signal, check Yes.
NOTE:
NOTE:
NOTE:
If the system has AUDIX Voice Power/Fax Attendant System, Integrated
Administration automatically sets Loop-Start Reliable Disconnect to Yes.
Outmode Signaling
The system is factory-set to generate touch-tone signals when users dial outside
calls. Identify any rotary-dial trunks that are connected to the system so that
rotary-dial signals can be used for these trunks.
NOTE:
NOTE:
NOTE:
Touch-tone, single-line telephone users cannot make calls using rotary-dial
trunks unless their phones allow them to switch between touch tones and
rotary dial pulses. Check with the local or long-distance telephone company
to determine which, if any, trunks connected to the system are rotary-dial
trunks.
Planning Form Instructions
In the Outmode Signaling column on Form 2c, do one of the following:
For touch-tone trunks (factory setting), put a check in the TT column.
For rotary-dial trunks, put a check in the R column.
section in
Chapter 4
3
of this manual.
Issue 1
June 1997
Page 3-12
Advertisement
Table of Contents
