Direct Station Selector - Lucent Technologies MERLIN LEGEND Release 5.0 System Planning Manual

MERLIN LEGEND Communications System Release 5.0
System Planning 555-650-112
4 Features
Operator Features
NOTE: NOTE: NOTE:
You cannot assign an operator to either Follow Me calls or calls to QCC
operator extensions.
2. In the QCC Queue Priority Level column, write the level for each call type.
Assign a value of 1 (high priority) through 7 (low priority). The factory
setting is 4.
Voice Announce
This section contains instructions to enable a QCC operator to originate Voice
Announce (VA) calls. When enabled, the Call 5 button on the QCC can originate
Voice Announce calls.
NOTE: NOTE: NOTE:
QCCs cannot receive Voice Announce calls.
Planning Form Instructions
Under the Voice Announce heading on Form 6a, do one of the following:
To prevent QCC operators from originating Voice Announce calls, check
the Disable box (factory setting).
To allow QCC operators to originate Voice Announce calls, check the
Enable box.

Direct Station Selector

Use these instructions only if the system has Direct Station Selectors (DSSs)
connected to MLX operator consoles. Otherwise, skip to the next section,
''Group-Assigned
This section contains instructions for recording the range of extensions assigned
to the Page buttons, and for renumbering the extensions for Park so that the
extensions fall within the Page button ranges.
Page Buttons
This section contains instructions for recording the range of extensions assigned
to each of three Page buttons. The three Page buttons should be set to reach
ranges of numbers that include the extension numbers in the extension
numbering plan and reflect the number of extensions available:
If one DSS is connected to an operator console, set each Page button for a
range of 50 numbers (matching the 50 available extensions).
Features''.
4
Issue 1
June 1997
Page 4-20