Lucent Technologies MERLIN LEGEND Release 5.0 System Planning Manual page 67

MERLIN LEGEND Communications System Release 5.0
System Planning 555-650-112
2 Control Unit Configuration
Numbering the System
4. If the system has a VMS, add the TTRs required for the VMS (Step 1) to
the system requirements for TTRs (Step 3). This is the total number of
TTRs required for the system.
Jack for Primary Operator Position
The factory setting for the primary operator position is the lowest extension jack
on the first MLX or analog multiline telephone module. You cannot change the
factory setting for the primary operator position.
The primary operator position uses two types of operator consoles:
Direct-Line Console (DLC). Can be assigned to either a digital or analog
extension jack.
Queued Call Console (QCC). Can be assigned only to a digital extension
jack, and the MLX-20L is the only telephone that can be used as a QCC.
If the system includes QCCs, the primary operator position must be a QCC.
Planning Form Instructions
Mark jack assignments on Form 2a:
1. Do one of the following:
2. Obtain the logical ID of the extension jack for the system programming
console by referring to the System Operating Conditions heading, Form 1
(page 2).
3. Identify the logical ID for the system programming console by writing SPC
beside the appropriate logical ID in the Log. ID column of Form 2a.
4. Write either the name of the person who will program the system or the
location of the system programming console in the Person, Location, or
Function column. Then proceed to Step 5.
Do one of the following:
5.
6. To indicate the primary QCC operator position:
If the system uses a system programming console, proceed to
Step 2.
If the system does not use a system programming console, skip to
Step 5.
To indicate the primary QCC operator position for a system with one
or more QCCs, proceed to Step 6.
To indicate the primary DLC operator position for a system with one
or more DLCs, skip to Step 7.
Locate the first extension jack showing a D (digital) jack type and
write QCC beside the preprinted logical ID number.
2
Issue 1
June 1997
Page 2-17