Did Trunks (Hybrid/Pbx Mode Only) - Lucent Technologies MERLIN LEGEND Release 5.0 System Planning Manual
Communications system
Hide thumbs
Also See for MERLIN LEGEND Release 5.0:
- System programming manual (949 pages) ,
- Feature reference (869 pages) ,
- Maintenance and troubleshooting manual (468 pages)
Table of Contents
Advertisement
MERLIN LEGEND Communications System Release 5.0
System Planning 555-650-112
3
Lines/Trunks
Selecting Line/Trunk Options
NOTES:
1. If you have checked the Incoming or two-way column for a tie-trunk's
direction and Immediate for its incoming signaling type, you cannot use
the Touch-Tone setting for Inmode.
2. Touch-Tone outmode can be used with Outtype Immediate trunks, but
Touch-Tone Inmode cannot be used with Intype Immediate Trunks.
b.
6.
To indicate whether the system provides a dial tone for people calling in on
a tie trunk, check one of the following for each tie trunk under the Dial Tone
heading:
For Answer Supv. Time, do one of the following:
7.
8.
Under the Disconnect Time heading, do one of the following:
Proceed to the next
DID Trunks (Hybrid/PBX Mode Only)
Use these instructions only if Direct Inward Dial (DID) trunks are connected to the
system. Otherwise, skip to the next
!
SecurityAlert:
DID numbers that correspond to the remote access code can be used to
make calls on the system's trunks, leading to toll abuse and/or fraud. (See
Appendix A, ''Customer Support
security.)
This section contains instructions for setting the following options for DID trunks:
Type of DID Trunks
Expected Digits
Under the Outmode heading, check either the Touch-Tone column
or the Rotary column (factory setting) for each outgoing-only and
each two-way tie trunk.
If the system provides a dial tone, check Remote (factory setting).
If the system does not provide a dial tone, check Local.
To keep the factory setting, check the 300 column.
To change to a new value, write the new value (20 to 4800 ms) in
the Other column. (Use 20-ms increments.)
To keep the factory setting, check the 300 column.
To change to a new value, write the new value (140 to 2400 ms) in
the other column. (Use 10-ms increments.)
section,''DID Trunks (Hybrid/PBX Mode
3
section,''Assigning
Lines/Trunks''.
Information'', for more information about
Issue 1
June 1997
Page 3-37
Only)''.
Advertisement
Table of Contents
