Function Information; Selecting Line/Trunk Options - Lucent Technologies MERLIN LEGEND Release 5.0 System Planning Manual

MERLIN LEGEND Communications System Release 5.0
System Planning 555-650-112
3 Lines/Trunks

Selecting Line/Trunk Options

Function Information

If the system has AUDIX Voice Power/Fax Attendant System , you can use the
Function column to indicate which service is available for those jacks. You can
also use this column to indicate whether a jack connects a personal line and,
therefore, has an owner.
Planning Form Instructions
In the Function column of Form 2c, do one of the following:
If a jack is used for a special purpose, note the purpose. For example, if the
system has AUDIX Voice Power/Fax Attendant System, indicate the
service by writing one of the following for the appropriate jack:
If a jack is used for a personal line, write the extension number of the
telephone.
Proceed to the next section,
Selecting Line/Trunk Options
You can select the following options for the incoming trunks connected to the
system:
Loop-Start Reliable Disconnect
Outmode Signaling
Toll-Call Prefix Dialing Requirements (Toll Type)
Hold Disconnect Interval
QCC Operator to Receive Calls (Hybrid/PBX mode only)
QCC Queue Priority (Hybrid/PBX mode only)
Pools
Remote Access
DS1 Connectivity
Tie Trunks
DID trunks
— For Automated Attendant, write AA.
— For Call Answer, write CA.
— For Information Service, write IS.
— For Message Drop, write MD.
— For Voice Mail, write VM.
— For Fax Response, write FR.
''Selecting Line/Trunk
3
Options''.
3
Issue 1
June 1997
Page 3-10