Lucent Technologies MERLIN LEGEND Release 5.0 System Planning Manual page 254

MERLIN LEGEND Communications System Release 5.0
System Planning 555-650-112
6 Modifications
Adding to the System
5. If analog multiline telephones require either voice and data or Voice
Announce to Busy, two consecutive telephone jacks are required.
6. If you are connecting T/R equipment to the 008, 408, or 408 GS/LS
modules, a GPA is required.
2. On Form 1 (page 2), System Planning, review the completed Control Unit
Diagram and determine whether the module type needed is present. Do
one of the following:
3. Determine whether there are jacks available on the module for the new
line/trunk, auxiliary equipment, or telephone by referring to Form 2a,
System Numbering: Extension Jacks, or Form 2c, System Numbering:
Line/Trunk Jacks. Do one of the following:
4. Plan the placement of the new module required to support the line/trunk,
auxiliary equipment, or telephone by reviewing the guidelines that follow
and deciding where the new module should be placed.
If the module is not in the control unit, skip to Step 4.
If the module type needed is already in the control unit, proceed to
Step 3.
If there are sufficient jacks available on an existing module, plan to
connect the added line/trunk, equipment or telephone to them. Skip
to Step 6.
If no jacks are available, proceed to Step 4.
The power supply module must be placed in the far left slot of each
carrier.
The processor module must be installed in Slot 0 of the basic
carrier.
Line/trunk and/or extension modules can be placed in any order in
Slots 1 through 17 (with two expansion carriers), with the following
conditions:
— Install the modules in each carrier from left to right, with no
empty slots between modules.
— If the system includes a QCC, the 008 MLX module that
supports it must be the first extension module in the control
unit.
Issue 1
June 1997
Page 6-4