Lucent Technologies MERLIN LEGEND Release 5.0 System Planning Manual page 132

MERLIN LEGEND Communications System Release 5.0
System Planning 555-650-112
3 Lines/Trunks
Assigning Telephone Buttons
For multiline telephone users:
You can assign SA Voice, SA Ring, and SA Orig Only buttons and up to
27 SSA/SA buttons to each telephone. However, use the factory setting of
3 to ensure that when each user is busy on a call at least one additional
button is available to receive a call and another is available to make a call.
This leaves the rest of the buttons on multiline telephones free for
customizing.
If you plan to use Automatic Route Selection (ARS), consider keeping the
factory-set button assignments. Since ARS picks the appropriate route,
there is no need for Pool buttons.
Consider assigning SSA buttons to small groups of users who need to
answer and distribute each other's calls easily or to join conversations.
Each SSA button you assign corresponds to an SA Ring or SA Voice
button on another telephone. Therefore, to provide complete coverage
within the group, you must be sure that each SA Ring and SA Voice
button assigned to a telephone is also assigned to other members of the
group. Each SA Ring or SA Voice button on a telephone can be assigned
as an SSA button on up to 16 other telephones.
Assign a Pool button when a specific trunk pool (for example, BRI, WATS
or FX) is used frequently. Also consider assigning Pool buttons if you do
not plan to use ARS and the system includes only one or two pools.
Assign personal line buttons when an exclusive private number is needed,
for example, for a company executive. Any line/trunk connected to the
system can be used as a personal line as long as it is not in a trunk pool.
For single-line telephones, answering machines, fax machines, or any other
device connected to an 012, 016, or 008 OPT module:
The settings for SA buttons can be changed (see below); however, factory
settings should be adequate to meet most user needs, since SA buttons
can be used to make and receive both inside and outside calls.
Single-line telephones cannot have additional SA or SSA buttons.
However, single-line telephones connected through an 012, 016, or 008
OPT module can have SA buttons removed from them. Removing all but
one SA button from Single-line telephones will disable features such as
Transfer, Conference, and any other feature that requires more than one
SA button.
NOTE:
On a DLC, there can be 10 System Access buttons (including SA
Orig Only), but no SSA buttons. On a QCC, no buttons can be
programmed, however, if the QCC Voice Announce feature has
been enabled, the Call5 button becomes a VA (Voice Announce)
button.
Issue 1
June 1997
Page 3-50