Lucent Technologies MERLIN LEGEND Release 5.0 System Planning Manual page 108

MERLIN LEGEND Communications System Release 5.0
System Planning 555-650-112
3 Lines/Trunks
Selecting Line/Trunk Options
3. Select the Channel Direction.
4. Select and Outgoing Signaling Type.
5. Select both the Incoming and Outgoing Signaling Mode.
PRI Service
Use these instructions only if the type of service on a 100D module is PRI.
Otherwise, skip to the next section,
PRI is a standard access arrangement of Integrated Services Digital Network
(ISDN) service that may be used to connect the system to another switch over a
DS1 facility.
This section contains instructions for recording decisions about the following
options for each PRI facility:
B-channel groups
PRI services (incoming and outgoing) according to B-channel group
Line Appearance Routing (incoming services)
Dial Plan Routing (incoming services; Hybrid/PBX mode only)
Outgoing Tables (Network Selection Table, Special Services Table, and
Call-by-Call Service Table)
Telephone Number to Send station identification or automatic numbering
information (SID-ANI) information
Test Telephone Number(s)
Timers and Counters
Terminal Equipment Identifier (TEI)
After completing the procedure for filling in the module information on Form 3b,
pages 1 and 2, continue to the next section to fill in PRI options.
Number of Digits to Delete. Enter the number of digits to delete
(0–4) in order to match the Dial Plan. The factory setting is 0.
Number of Digits to Add. Enter the number of digits to add
(0–9999) to the collected digits in order to determine a routing
pattern. The factory setting is 0.
Select either Incoming, Outgoing, or Two Way.
Select either Wink, Auto, or Delay. The factory setting is Wink.
Select either Touch Tone or Rotary. The factory setting is Rotary.
3
''Tie Trunks''.
Issue 1
June 1997
Page 3-26