Lucent Technologies MERLIN LEGEND Release 5.0 System Planning Manual page 115

MERLIN LEGEND Communications System Release 5.0
System Planning 555-650-112
3 Lines/Trunks
Selecting Line/Trunk Options
7. For all call-by-call B-channel groups, to route all outgoing calls over a
call-by-call B-channel group, you must program the Call-by-Call Service
Table to direct the system to properly route calls. Record table entries
(maximum: 10) on Form 3b (page 8):
a.
b.
c.
d.
In the Pattern to Match cell, write the dial pattern to match (up to 8
digits). No wildcards are permitted.
In the Call Type cell, indicate the type(s) of calls that will be
associated with the pattern by doing one of the following:
If all outgoing calls will be voice calls (for example, Megacom
WATS), write Voice.
If all outgoing calls will be data only (for example,
ACCUNET), write Data.
If outgoing calls may be either voice or data (for example,
SDN), write Both.
NOTE:
If you indicate Both, make sure the service can support both voice
and data calls.
In the Service cell, write one of the following:
AT&T Toll. (for 4ESS or 5ESS, see Form 3b, page 1)
Megacom WATS, Megacom 800, ACCUNET SDS, Software
Defined Network (SDN), MultiQuest, and Long Distance.
5ESS Local. (For switch type 5ESS, see Form 3b, page 1)
OUTWATS, 56/64 Digital, Virtual Private Network, and
INWATS.
MCI Toll. (for DMS-250 or DEX600E, see Form 3b, page 1)
MCI Prism, MCI VNet, MCI 800 and MCI 900.
DMS-100 Local. (for a DMS-100, see Form 3b, page 1) DMS
Private Network, DMS INWATS (Inward Wide Area
Telephone Service), DMS OUTWATS (Outward Wide Area
Telephone Service), DMS FX (foreign exchange), DMS Tie
Trunk.
Other. Call-by-Call, Other.
If the system will need to delete digits, write the number of digits to
delete (0 8). (The system deletes from the first digit onward.)
Issue 1
June 1997
Page 3-33