Hardware Installation; Safety Cautions - D-Link DGS-1210 Series Manual

2 Hardware Installation

2
Hardware Installation
This chapter provides unpacking and installation information for the D-Link Smart Managed Switch.

Safety Cautions

To reduce the risk of bodily injury, electrical shock, fire and damage to the equipment, observe the following
precautions:
Observe and follow service markings
•
 Do not service any product except as explained in your system documentation.
 Opening or removing covers that are marked with the triangular symbol with a lightning bolt may
expose you to electrical shock.
Only a trained service technician should service components inside these compartments.
•
• If any of the following conditions occur, unplug the product from the electrical outlet and replace the
part or contact your trained service provider:
 The power cable, extension cable, or plug is damaged.
 An object has fallen into the product.
 The product has been exposed to water.
 The product has been dropped or damaged.
 The product does not operate correctly when you follow the operating instructions.
Keep your system away from radiators and heat sources. Also, do not block cooling vents.
•
• Do not spill food or liquids on your system components, and never operate the product in a wet
environment. If the system gets wet, contact your trained service provider.
Do not push any objects into the openings of your system. Doing so can cause fire or electric shock by
•
shorting out interior components.
• Use the product only with approved equipment.
Allow the product to cool before removing covers or touching internal components.
•
Operate the product only from the type of external power source indicated on the electrical ratings label.
•
If you are not sure of the type of power source required, consult your service provider or local power
company.
• Also, be sure that attached devices are electrically rated to operate with the power available in your
location.
Use only approved power cable(s). If you have not been provided with a power cable for your system or
•
for any AC powered option intended for your system, purchase a power cable that is approved for use
in your country. The power cable must be rated for the product and for the voltage and current marked
on the product's electrical ratings label. The voltage and current rating of the cable should be greater
than the ratings marked on the product.
To help prevent electric shock, plug the system and peripheral power cables into properly grounded
•
electrical outlets.
These cables are equipped with three-prong plugs to help ensure proper grounding. Do not use
•
adapter plugs or remove the grounding prong from a cable. If you must use an extension cable, use a
3-wire cable with properly grounded plugs.
Observe extension cable and power strip ratings. Make sure that the total ampere rating of all products
•
plugged into the extension cable or power strip does not exceed 80 percent of the ampere ratings limit
for the extension cable or power strip.
• To help protect your system from sudden, transient increases and decreases in electrical power, use a
surge suppressor, line conditioner, or uninterruptible power supply (UPS).
Position system cables and power cables carefully; route cables so that they cannot be stepped on or
•
tripped over. Be sure that nothing rests on any cables.
Do not modify power cables or plugs. Consult a licensed electrician or your power company for site
•
modifications.
• Always follow your local/national wiring rules.
D-Link Smart Managed Switch User Manual
18