Setting The Saving Time Of Trap Packets - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
The range of the packet queue length is 1 to 1000 with the default value as 100.
# Set the packet queue length of the host sending the Trap packets as 200.
[3Com] snmp-agent trap queue-size 200

9.2.15 Setting the Saving Time of Trap Packets

The configuration is used to set the saving time of Trap packets, and all the Trap
packets exceeding this time will be deleted.
Perform the following operations in the system view.
Table 9-16 Set the saving time of Trap packets
Set the saving time of Trap packets
Restore to the default value of Trap
packets saving time
The range of Trap packets saving time is 1 to 2592000, with the default value as 120
seconds.
# Set the saving time of Trap packets as 60 seconds.
[3Com] snmp-agent trap life 60
9.3 Displaying and Debugging
After the above configuration, execute the display command in any view to display the
running of the SNMP configuration, and to verify the configuration, but the debugging
command should be performed in the user view.
Table 9-17 Monitoring and maintenance of SNMP
Display the versions enabled by SNMP
Display the statistics of SNMP packets
Display the engine ID of the current
device
Display the group name, security mode,
status of views, and storage modes of
groups
Display all the SNMP user names in a
group user name list
Display the community name of the
current configuration
Operation
Operation
3Com Corporation
9-10
Chapter 9 SNMP Configuration
Command
snmp-agent trap life seconds
undo snmp-agent trap life
Command
display snmp-agent sys-info version
display snmp-agent statistics
display snmp-agent { local-engineid |
remote-engineid }
display snmp-agent
[ group-name ]
display snmp-agent
[ engineid engineid
user-name | group group-name ] *
display snmp-agent community [ read
| write ]
group
usm-user
| username