3Com 3C13636 Configuration Manual page 223

3Com Router 3000 Ethernet Family
Configuration Guide
By default, the source IP address in each packet sent by the SSH client is the IP
address of the interface where the packet is sent out.
Note:
You may specify a source IP address for the packets sent by the Telnet server with the
ssh2 source-interface command or with the ssh2 source-ip command. If both
commands are configured, the one configured later overrides the previous one.
11.6.5 Displaying and Debugging
After the above configuration, execute display command in any view to display the
running of the SSH configuration, and to verify the configuration.
The task of displaying and debugging SSH is used to view the configuration of various
SSH users to utilize the system resource better and accomplish the secure information
connection.
Table 11-32 View relevant information about SSH
View the pubic key of host and server
key pair
Display the RSA public key of client
Display SSH status information and
session information
Display SSH user information
Display the current source IP address
setting of the SSH server
Display the current source IP address
setting of the SSH client
Executing the debugging command in user view.
Table 11-33 Debug information on SSH
Enable SSH debug
Operation
Operation
3Com Corporation
11-26
Chapter 11 Terminal Services
Command
display rsa local-key-pair public
display rsa peer-public-key [ brief |
name keyname ]
display ssh server { status | session }
display ssh
[ username ]
display ssh-server source-ip
display ssh2 source-ip
Command
debugging ssh server { vty index | all }
user-information