3Com 3C13636 Configuration Manual page 799

3Com Router 3000 Ethernet Family
Configuration Guide
# Configure Originating RP.
[RTB-msdp] originating-rp loopback0
[RTB-msdp] quit
# Configure the candidate RP and BSR.
[RTB] pim
[RTB-pim] c-rp loopback 10
[RTB-pim] c-bsr loopback 10 30
2) Configure RTA:
# Enable multicast.
[RTA] multicast routing-enable
# Configure the IP address of interface Loopback0.
[RTA] interface loopback0
[RTA-LoopBack0] ip address 10.21.1.1 255.255.255.255
[RTA-LoopBack0] quit
# Configure the IP address of interface Loopback10 and enable PIM-SM.
[RTA] interface loopback10
[RTA-LoopBack10] ip address 10.1.1.1 255.255.255.255
[RTA-LoopBack10] pim sm
[RTA-LoopBack10] quit
# Configure the IP address of interface Serial1/0/0 and enable PIM-SM.
[RTA] interface serial 1/0/0
[RTA-Serial1/0/0] ip address 10.21.2.1 255.255.255.0
[RTA-Serial1/0/0] pim sm
[RTA-Serial1/0/0] undo shutdown
[RTA-Serial1/0/0] quit
# Configure the IP address of interface Serial1/1/0 and enable PIM-SM.
[RTA] interface serial 1/1/0
[RTA-Serial1/1/0] ip address 10.21.3.1 255.255.255.0
[RTA-Serial1/1/0] pim sm
[RTA-Serial1/1/0] undo shutdown
[RTA-Serial1/1/0] quit
# Configure OSPF route.
[RTA] ospf
[RTA-ospf-1] area 0
[RTA-ospf-1-area-0.0.0.0] network 10.21.2.0 0.255.255.255
[RTA-ospf-1-area-0.0.0.0] network 10.21.3.0 0.255.255.255
[RTA-ospf-1-area-0.0.0.0] network 10.1.1.1 0.0.0.0
[RTA-ospf-1-area-0.0.0.0] network 10.21.1.1 0.0.0.0
[RTA-ospf-1-area-0.0.0.0] quit
3Com Corporation
5-16
Chapter 5 MSDP Configuration